Engine Tachometer, hour meter, timer
A brand-new, unused, unopened, undamaged item in its original
packaging (where packaging is applicable).
Hour meter used for Marine, ATV, Motorcycle, Snowmobile
Track the Service Life of Your Vehicle-oil changes, valve,
adjustments, spark plugs, etc^
Easy Installation-peel & stick, no wiring necessary, or attach
with enclosed hardware.
No Battery Require-connects to spark plug wire.
Works on Any Gas Engine.
We have 3 colors for this item: Black, blue, orange, color will be
sent randomly, pls leave us message if you have the special color
1. Wrap the included pick-up wire around the spark plug wire five
times. Start wrapping the pick-up wire about 4cm from the end of
spark plug boot. Use the included zip tie to secure the pick-up
wire wrapping as shown in the photo right.
2. Before continuing the installation, insert the pick-up wire Into
the rear of the meter. Start the motor to make sure the meter is
picking up the ignition signal. If it is, this will activate the
timer on the meter and the icon on the left of the LCD will flash.
You'll have to wait at least 6 minutes to increase the timer
display(1/10th of an hour). If it is not picking up the ignition
signal, slide the pick-up wrap closer to the spark plug boot.
3.1f the meter is successfully picking up the spark signal, run and
zip tie the pick-up along one of the throttle cables. Make sure the
pick-up wire can not make contact with the engine. Also, make sure
you leave enough (about 8 cm) so removing the spark plug wire is
possible. Keep in mind the general location of final mounting
location on the frame spare.
4. Securing Method:
A. Drilling into your frame with 2.5mm socket, then secure it to
the frame coming with two pick-up screws.
B. Using padded double-sided tape on the backside of the meter and
secured it to the frame spar with zip ties. That's all there is to
the installation. Now you're set to accurately track your
maintenance. Don't forget to record the metered time when
Compatibility: All motorcycle models (anything with a spark plug
really should work)
Hardware Included: Meter, pick-up wire, two screws
Tools Required: 2. Smm socket to remove shroud, wire cutters.&